Operating Your Wireless Controller - Lionel G-Gauge Steam Set Owner's Manual

Operating your train

Operating your wireless controller

T
urn your Wireless Controller to the ON position by sliding the button on the right side of the
controller up. An LED on top of the dial will light to indicate the power is on (See Figure 7 on
page 10). See Figures 8 and 9 on page 12 for button operations.
Note!
The controller must be within 10 feet of the engine to operate the train. The controller
may not operate if placed flat on the ground even if it is near the train.
Forward
Turn the dial towards the green FORWARD position to move the train forward. There are three
speeds forward and the more you turn the dial along the green arrow the faster the train will run.
Stop
Turning the dial to the top will stop the train. Note that it may take up to several seconds for the
train to come to a complete stop depending on how fast it was going. Make sure to bring the train to
a complete stop before changing direction.
Reverse
Turn the dial towards the blue REVERSE position to have the train move in reverse. Again,
there are three speeds in reverse. The more you turn the dial along the blue arrow the faster
the train will go.
Bell
Pressing the BELL button activates the engine's bell sound.
Center Button (Depending on which set purchased)
Pressing the UNMARKED center button activates a special announcement.
Whistle
Pressing the WHISTLE button activates the engine's whistle.
11