Module State Transitions; Figure 10: Module State Transition Diagram; Table 1: Java At Commands - Siemens TC65 JAVA User Manual

TC65 JAVA User's Guide
Strictly confidential / Draft
4.4.2

Module State Transitions

State 1: Default, no Java
appl. running
close I2C
State 2: no Java appl.
running, using I2C
close SPI
open SPI
State 3: no Java appl.
running, using SPI
Note: No AT parser is available over serial interface ASC0 or ASC1 while a Java application
is running on the module.
• System.out is available on ASC1 for debugging while a Java application is running.
• Comparison of Java AT command APIs:

Table 1: Java AT commands

Voice calls
incoming
outgoing
Java AT
command API
with CSD
Java AT
command API
without CSD
indicates that the functionality is available from the
--- indicates that the functionality is not available from the
1)
except for AT commands related to data calls
2)
only two
Java AT command APIs
TC65 JAVA User's Guide_V01
switch on
no Java autostart
start java: at^sjra
destroy java application
open I2C
destroy
Java application
destroy java application
start java: at^sjra

Figure 10: Module State Transition Diagram

Data calls SMS
incoming incoming
outgoing outgoing
-
can be used in parallel to transmit GPRS data
Page 23 of 69
Java autostart
open I2C
start java: State 5: Java active,
at^sjra using I2C
State 6: Java active,
using SPI
GPRS Phonebook
connection management
2)
2)
Java AT command API
Java AT command API
s
State 4: Default,
Java active
close I2C
close SPI
open SPI
AT
commands
1)
11.03.2005