Wps Station Screen; Scheduling Screen - ZyXEL Communications LTE3302-M432 User Manual

7.9 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this screen, click
Configuration > Network > Wireless LAN > WPS Station tab.
Note: After you click Push Button on this screen, you have to press a similar button in the
wireless station utility within 2 minutes. To add the second wireless station, you have to
press these buttons on both device and the wireless station again after the first 2
minutes.
Figure 53 Configuration > Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Table 32 Configuration > Network > Wireless LAN > WPS Station
LABEL
Push Button
Or input station's PIN
number

7.10 Scheduling Screen

Use this screen to set the times your wireless LAN is turned on and off. Wireless LAN scheduling is disabled
by default. The wireless LAN can be scheduled to turn on or off on certain days and at certain times. To
open this screen, click Configuration > Network > Wireless LAN > Scheduling tab.
Chapter 7 Wireless LAN
DESCRIPTION
Use this button when you use the PBC (Push Button Configuration) method to configure
wireless station's wireless settings.
Click this to start WPS-aware wireless station scanning and the wireless security information
synchronization.
Use this button when you use the PIN Configuration method to configure wireless station's
wireless settings.
Type the same PIN number generated in the wireless station's utility. Then click Start to
associate to each other and perform the wireless security information synchronization.
LTE3302-M432 & LTE3312-M432 User's Guide
85