Connection With Multi-Pole Cable And Ribbon Cable Terminal - Bürkert Type 8691 Operating Instructions Manual

10.4.3 connection with multi-pole cable and ribbon cable terminal
As an alternative to the bus connection model with 4-pole circular plug, there is the control head with multi-pole
cable (M12 circular plug) and ribbon cable terminal. The wiring diagram of the circular plug corresponds to the bus
connection of the M12 4-pole circular plug (see "Figure 25" and "Figure 26") and can easily be connected to the
ribbon cable terminal (see "Figure 32").
Figure 32: Control head 8691 with multi-pole cable and ribbon cable terminal
handling the ribbon cable terminal
The multi-pole cable features a ribbon cable terminal - with M12 plug-in connector branch circuit - for AS-Interface
cable harness. The ribbon cable terminal contacts the AS-Interface cable harness by means of penetration technology
which allows installation by "clipping in" the AS-Interface cable harness without cutting and without removing insulation.
Figure 33: Ribbon cable terminal
The teach function can now be used to automatically determine and read in the end positions of the valve
(description of the teach function see chapter "10.5 Teach function (calibrating the end position)").
38
Screws
M12 plug-in con-
nector branch circuit
english
Type 8691
AS-Interfaceinstallation
Work steps:
→
Open the ribbon cable terminal
(loosen screws and remove cover)
→
Insert cable harness conclusively
→
Close ribbon cable terminal again
→
Tighten screws
Slightly undo thread-forming screws
(approx. 3/4 turn to the left) and position them on the
existing tapped bore and screw in.