Procedure - Ram Mount Assembly; Torque Measurement; Step 1A - Attach Ram Ball To Vehicle; Mounting Dimensions - Honeywell Thor VM3 User Manual

Procedure - RAM Mount Assembly

Equipment Needed: Sockets, screwdriver and a Torque wrench capable of measuring to 50 inch pounds (5.64±.56 N/m).
Note: Torquing tool is not supplied by Honeywell. Tools needed to attach the RAM Clamp Mount to the vehicle are not
supplied by Honeywell.

Torque Measurement

You will need a torquing tool capable of torquing to 20 inch pounds (1.10 N/m). Torque all screws and bolts according
to the following table:
For these nuts...
10-32 lock nuts
Step 1a – Attach RAM Ball to Vehicle
Note: If you are using the RAM clamp mount, please go to
you are using the RAM plate mount, please go to
(page 1-21).
1. Determine the position for mounting the RAM ball base. Be sure to position the RAM bracket to allow access to
the switches and ports on the bottom of the Thor VM3.
2. Attach the RAM ball base to the vehicle mounting surface using three or four 1/4 bolts (not included) or equivalent
fasteners. If the mounting kit includes cone washers, use those as illustrated below.
IMPORTANT: Mount to the most rigid surface available.

Mounting Dimensions

Note: Drill and tap holes for three 1/4 bolts. Drawing not to scale.
3.69" / 93.73 mm
120º
Torque to
17 - 20 in/lb (0-95 - 1.10 N/m)
60º 60º
2.75" / 69.85 mm
120º
Step 1b – Mount RAM Clamp to Vehicle
Step 1c – Attach RAM Plate to Vehicle and Attach RAM Ball
(page 1-20). If
1 - 19