Furuno FELCOM 15 Installation Manual page 25

2. Unfasten four pan head screws (M3x8) to remove the RF cover (S).
3. Fasten three pan head screws (M3x8, supplied with the kit) to attach the GPS board to
the RF cover.
4. Attach the 7P connector from the RF cover to the JI on the GPS board.
RF cover
5. Pass the cable from the GPS board through the hole on the RF cover, and then connect
it to J4 on the RF CON/CPU board.
GPS board
Pass the cable
through this hole.
RF cover
Pass the cable
under the RF cover.
Fix the cable with the clamp.
Fasten the cable at the clamp next to the J4 connector.
6. Remount the RF cover (S) using four pan head screws (M3x8) unfastened at step 2.
7P connector
Pan head screw
M3x8, 4 pcs.
(marked with "#")
RF cover (S)
Removing RF Cover (S)/Fixing GPS Board
RF CON/CPU board
J4
19
4. INSTALLATION OF GPS BOARD (OPTION)
Cable
Pan head screw
M3x8, 3 pcs.
GPS board
J1
# #
#
#
Grommet
How to treat connectors
1. Attach the connector at right angle.
If not, connector pins may be bent.
2. After connecting connector assemblies, the load
on their cables should be as below.
less than 2.94N (300gf)
less than 9.8N (1kgf)
less than 2.94N (300gf)