Furuno FELCOM 15 Installation Manual page 17

8D-FB-CV (50 m)
Outer Sheath
Dimensions in millimeters.
Armor Inner Sheath
50
Cover with heat-shrink tubing and heat.
30
Clamp
Gasket
Nut
(reddish
brown)
Trim shield here.
Trim aluminum
tape foil here.
Clamp Nut
Solder through
the hole.
How to fabricate antenna cable 8D-FB-CV
Remove outer sheath and armor by the
Shield
dimensions shown left.
Expose inner sheath and shield by the
dimensions shown left.
30
Remove insulator and core by 10 mm.
10
Twist shield end.
Slip on clamp nut, gasket and clamp as shown
left.
Clamp
Aluminum Foil
Fold back shield over clamp and trim.
Cut aluminum foil at four places, 90 from one
another.
Insulator
Fold back aluminum tape foil onto shield and trim.
1
Expose the insulator by 1 mm.
5
Expose the insulator by 5 mm.
Pin
Slip the pin onto the conductor. Solder them
Shell
together through the hole on the pin.
Insert the pin into the shell. Screw the clamp
nut into the shell.
(Tighten by turning the clamp nut. Do not
tighten by turning the shell.)
11
2. WIRING