To Change Your Master Code; Quick Arming; Phone Module - ADEMCO Security System VISTA-10SE User Manual

Duress Code
(Continued)
To Change Your Master
Code

Quick Arming

Ask your installer if "Quick
Arming" is active for your
system; if so, check here:

Phone Module

Ask your installer if your
system includes a phone
module; if so, check here:
SECURITY CODES (Continued)
To program a Duress code:
Enter your Master Code + 8 + 8 + [desired 4-digit duress code].
The keypad will beep once.
Note: The Duress code must differ from the Master Code or any other User's Code.
To change the Duress code:
Enter Master Code + 8 + 8 + [new 4-digit duress code].
To delete the Duress code:
Enter your Master Code + 8 + 8, and then stop. When the keypad beeps once it signifies
that the code has been deleted.
1. Enter your Master code and press the CODE [8] key.
2. Enter "2".
3. Enter your new Master code.
4. Enter your new Master code again. The keypad will beep 3 times, indicating
acceptance.
If your system supports "Quick Arming", the "#" key can be pressed in place of the
security code when arming the system. The security code is always required, however,
when disarming the system.
If your system includes a phone module, your installer will have programmed a 2-digit
phone access code for your system. Be sure to obtain this phone code from your installer.
Complete information regarding the use of this phone access feature is provided in a
separate manual entitled PHONE ACCESS USER'S GUIDE, which accompanies the
phone module.
– 1 1 –