Testing The System - ADEMCO Security System VISTA-10SE User Manual

Using the The TEST key puts your system into the Test mode, which allows each protection point
to be checked for proper operation.
5 TEST Key
1. Disarm the system and close all protected windows, doors, etc. The keypad's READY
NO ALARM REPORTS
WILL BE SENT TO THE
2. Enter your security code and press the TEST key.
CENTRAL MONITORING
3. As the Test mode is entered, the external siren or bell will sound for 2 seconds and
STATION while the
system is in Test mode.
4. Open and close each protected door and window in turn and listen for the required
5. Walk in front of any interior motion detectors (if used) and listen for the required sound
N o t e : Wireless PIR (Passive Infrared) units will send signals out only if they have been
6. Follow the manufacturer's instructions to test all smoke detectors, to ensure that all

TESTING THE SYSTEM

TO BE CONDUCTED WEEKLY
message should be displayed and the READY indicator (if present) should be lit.
then turn off.
Each time a protection zone is faulted, the keypad sounds 3 beeps.
The keypad will sound a single beep every 40 seconds as a reminder that the system
is in the test mode.
If these sounds do not occur, call for service immediately.
sounds The identification of each faulted protection point should appear on the dis-
play.
as movement is detected. The identification of the detector should appear on the
display when it is activated.
inactive for 3 minutes.
are functioning properly. The identification of each detector should appear on the
display when each is activated.
– 2 4 –