HP 8642A Operation And Calibration Manual page 310

Adjustments Model 8642A;B
5-4
9. When "ENTER CURRENT MONTH .G8001" appears, key in a two digit number indicating the
month. Then press IHzl to continue.
10. When
"ENTER TODAYS DATE
.G8002" appears, key in a two digit number indicating the date.
(Example: For February 30 yOll would enter 30.) Then press IHzl to continue.
11. When "ENTER CURRENT YEAR .G8003" appears, key in last two digits of the current year.
(Example: For February 30, 1984 you would enter 84.) Then press IHzl to continue.
12. When
"ENTER MODULE CAL. ID
.G8004" appears, key in last five digits of the Mouule Cal
10
numher of the module you are running the Auto-Adjust Routine for. Then press IHzl to continue.
A2 EXAMPLE: The Module Cal
10
number is similar to the instrument serial !lumber but
appears on the modules. The A2 Module Cal 10 number can be found on the ribbon cable
connector at the left hand side of the A2 board Voul will see a label with a number similar to:
2412A/31458. So, you would enter
[!]
OJ
@] @] ~ Hz for the Module Cal
10 number.
13. Now the printer should respond by printing out the statistics of the module. See Figure 5-1. All
the information on the print out has been discussed previously, except the Calibration Method
number, which will be discussed in Interpreting Cal Data Stats later in this section.
MODULATION SECTION (A2) SELF"CALIBRATION
CALIBRATION DATE (MDY): 12/25/86
INSTR. MODEL
#:
HP
8642B
INSTALLED OPTIONS: 001
INSTR. SERIAL
#:
2427A00209
MODULE ID NUMBER: 9 MODULE CALIBRATION ID: 31458
CALIBRATION METHOD: 9995
Figllre 5-1. TypiL'a{ Modllle S((!h pril/(o/(( li'om HP 8M2 A I/(o-A
djill/
ROlin/inc.
14. The lemaining steps will be unique to each Module given in Section 8. Turn to the Section 8
Module Tab you are interested in. You will find the complete Auto-Adjust Procedure in the
Troubleshooting and Adjustments information. The procedure in Section 8 will include the above
less the detailed expla nation.