Table of Contents
Advertisement
6–Configuring RoCE
Preparing the Adapter
Preparing the Adapter
The following steps describe how to enable DCBX, and specify the RoCE priority
using the HII management application. For information about the HII application,
see
Chapter 5, Preboot Adapter
1.
In the Main Configuration Page, select Data Center Bridging (DCB)
Settings, and then click Finish.
2.
In the Data Center Bridging (DCB) Settings window, click the DCBX
Protocol drop-down. The QL45212 Adapter supports both CEE and IEEE
protocols. This value should match the corresponding value on the DCB
switch. In this example, select CEE.
3.
Click the RoCE Priority field, and type a priority value. This value should
match the corresponding value on the DCB switch. In this example, type 5.
4.
Click Back.
5.
When prompted, click Yes to save the changes. Changes will not take effect
unit after a system reset.
Configuration.
50
BC0154503-00 C
Advertisement
Table of Contents
Troubleshooting
