Quick Start; Installation Instructions; Step 1. Install The Adapter Hardware - Qlogic 8200 Series User Manual

Quick Start

Installation Instructions

This Quick Start section describes how to install and configure your new QLogic
converged network adapter in three simple steps:




CAUTION!

Step 1. Install the Adapter Hardware

To install the adapter hardware, you need to open the computer and locate the
appropriate bus slot. If necessary, consult your computer system manual for
instructions on how to remove the computer cover.
Follow these steps to install the adapter hardware:
1.
2.
3.
4.
5.
SN0054671-00 B
Step 1. Install the Adapter Hardware
Step 2. Install the Adapter Drivers
Step 3. Install QConvergeConsole
Step 4. Update the Flash
Keep the adapter in the antistatic bag until installation. The adapter contains
parts that can be damaged by electrostatic discharge (ESD). Before
handling the adapter, use standard methods to discharge static electricity.
Place the adapter on the bag when examining it. Retain the bag for future
use.
Power off the computer and all attached devices such as monitors, printers,
and external components.
Disconnect the power cable.
Remove the computer cover and find an empty PCIe
Pull out the slot cover (if any) by removing the screw or releasing the lever.
Install the low-profile bracket (if required).
®
x8 (or larger) bus slot.
®
xxiii