Qlogic QL45212 User Manual page 4

User's Guide—25Gb Intelligent Ethernet Adapter
QL45212
Added reference on CentOS on Step 2 and Step 3,
under "For RHEL"
Updated Step 1 command
rpm -ivh kmod-qlgc-fastlinq-<ver-
sion>.<arch>.rpm to
rpm -ivh qlgc-fastlinq-<ver-
sion>.<arch>.rpm
Added reference to CentOS on Step 2, under "For
RHEL"
Added note on CentOS.
Deleted reference to "modprobe -r qed and
modprobe -qede."
Added make install_libeqdr.
Updated parameter content and description.
Added "See Step 7 on Verifying the RoCE Configu-
ration on Linux on page 59 for more information."
Updated reference from "click View Log" to "click
View Installation Log" on Step 9, first bullet. Also
updated second bullet from "click OK", to "Click
CLOSE".
Updated screenshot for Step 8, Step 9.
Removed redundant content from "Installation
Options" topic.
Created new topic "Updating Dell DUP Using .BIN
File".
Updated note on Step 3.
Added new paragraph and table on FEC Mode
options.
Added screenshot of partition configuration details
on Step 4.
Added RoCE v1 and v2
"Installing Linux Drivers Using the src RPM Pack-
age" on page 14
"Installing Linux Drivers Using the kmp/kmod RPM
Package" on page 15
"Installing Linux Drivers Using the TAR File" on
page 15
"Installing the Linux Drivers without RoCE" on
page 11
"Installing the Linux Drivers with RoCE" on
page 16
"To install Linux drivers in an in-box OFED environ-
ment:" on page 16
Table 3-2 on page 17
"Statistics" on page 18
"Running the Dell Update Package in the GUI" on
page 19
Figure 3-7 on page 23
Figure 3-8 on page 24
"Installation Options" on page 24
"Upgrading Firmware" on page 31
"To enable NIC partitioning (NPAR), single root
input/output virtualization (SR-IOV), or both:" on
page 42
"NIC Configuration" on page 44
"To configure the maximum and minimum band-
width allocations for each partition:" on page 46
"Configuring RoCE" on page 48
iv BC0154503-00 C