Table of Contents
Advertisement
If a towing bracket is to be fitted after the vehicle is purchased, this must be
completed according to the instructions of the towing bracket manufacturer.
The attachment points for the towing bracket
The distance between the centre of the ball coupling and the ground should
never be lower than the measurement indicated when the vehicle is fully
loaded including the maximum resting weight.
Measurement for securing the towing bracket:
A
65 mm (minimum)
B
A
350 mm to 420 mm (fully laden vehicle)
C
A
357 mm
D
A
569 mm
E
A
875 mm
F
A
1,040 mm
G
Fitting a towing bracket
•
Observe the legal requirements in your country (e.g. the fitting of a sepa-
rate warning lamp).
•
Certain vehicle components, e.g. the rear bumper must be removed and
reinstalled. The towing bracket securing bolts must be tightened using a
torque wrench, and an electrical socket must be used to connect to the
vehicle's electrical system. This requires specialist knowledge and tools.
•
The figures in the illustration show the dimensions and attachment points
which must be observed if you are fitting a rear towing bracket.
WARNING
Towing brackets should be fitted by specialists.
•
If the towing bracket is incorrectly installed, there is serious danger of
an accident.
•
For your own safety, please observe the instructions provided by the
manufacturer of the towing bracket.
Safety First
A
are underneath the vehicle.
A
Handling instructions
Accessories, parts replacement and modifications
Caution
If the electrical socket is incorrectly installed, this could cause damage to the
vehicle's electrical system.
Tips and Maintenance
Technical Data
189
Advertisement
Table of Contents
