Seat Leon 2005 Owner's Manual page 106

Table of Contents

Advertisement

WARNING (continued)
If necessary, use the safety switch to disable the rear electric windows.
Make sure that they have been disabled.
Note
If the window is not able to close because it is stiff or because of an obstruc-
tion, the window will automatically open again ⇒ page 105. If this happens,
check why the window could not be closed before attempting to close it
again.
One-touch opening and closing
One-touch opening and closing means you do not have to
hold down the button.
Automatic closing (only the front side windows)
– Pull up the button for the window briefly to the second position.
The window closes fully.
One-touch opening
– Push down the button for the window briefly to the second posi-
tion. The window opens fully.
Reset the automatic closing function for the front side windows and
the automatic opening for all windows
– Close all windows.
Safety First
Handling instructions
– Use the key to lock the vehicle from outside and hold the key in
the lock position for at least one second. The one-touch function
is now ready for operation.
⇒ page 104, fig. 70
A
The buttons
window and two for closing it. This makes it easier to open or close windows
to the desired position.
One-touch closing does not work when the ignition has been switched off,
even if the key is in the ignition.
The automatic open and close function will not work if the battery has been
temporarily disconnected, or if the battery is flat. The function then has to be
reactivated.
The one-touch function and roll-back function will not work if there is a
malfunction in the electric windows. Contact an Authorised Service Centre.
Roll-back function
The windows have a roll-back function. This reduces the risk
of injuries when the windows are closing.
If a window is obstructed when closing automatically, the window stops
at this point and lowers immediately ⇒
If this happens, check immediately (within 10 seconds) why the window
could not be closed before attempting to close it again. After 10 seconds the
normal automatic function resumes.
If the window is still obstructed, the window stops at this point.
If there is no obvious reason why the window cannot be closed, try to
close it again within five seconds.
If you wait longer than 10 / 5 seconds, the window will open fully when you
operate one of the buttons. One-touch closing is reactivated.
Tips and Maintenance
Opening and closing
A
and
have two levels for opening the
1
2
.
Technical Data
105

Advertisement

Table of Contents
loading

Table of Contents