Package Checklist The Moxa PowerTrans switch is shipped with the following items. If any of these items are missing or damaged, please contact your customer service representative for assistance. • 1 Moxa PowerTrans Switch • RJ45 to DB9 console port cable •...
Gigabit / Fast Ethernet Interface Modules (slot 2) Rack Mounting Use four screws to attach the PT switch to a standard rack. Wall Mounting Use four screws to attach the PT switch to a Moxa wall mounting kit. Wiring Requirements WARNING Safety First! •...
Wiring the Power Input (110/220 VDC/VAC models) The PT-7710 (110/220 VDC/VAC models) has one set of power inputs, referred to as power input 1. The front view of the terminal block connector is shown here. STEP 1: Insert the L/N AC wires into the PWR1 terminals (L pin 1, N pin 2).
LED Indicators The front panel of the PT switch contains several LED indicators. The function of each LED is described in the table below. Color State Description System LEDs System has passed self-diagnosis test on boot-up and is ready to run. GREEN System is undergoing the STAT...
Color State Description Mode LEDs The corresponding module port’s link is active. The corresponding module port’s data LNK/ACT GREEN Blinking is being transmitted. The corresponding module port’s link is inactive. The corresponding module port’s data is being transmitted at 10 Mbps. The corresponding module port’s data SPEED GREEN...
Need help?
Do you have a question about the PT-7710 Series and is the answer not in the manual?
Questions and answers