Pitco 35C+ Installation, Operation And Maintenance Manual page 4

SAFETY
The cooker must be electrically grounded in accordance with local
This cooker is equipped with a three prong safety plug. This safety plug
protects operators from electrical shock in the event of an equipment malfunc-
tion. DO NOT remove the grounding (third) prong from this plug.
A cooker that is equipped with casters and a flexible power cord must be
connected to the gas supply with a Quick-Disconnect device. This quick
disconnect must comply with ANSI Z24.41-1989. A restraining cable must
be installed to limit the movement of the cooker.
There is an open gas flame inside the cooker. The unit may get hot enough
to set nearby materials on fire. Keep the area around the cooker free from
combustible materials.
Ensure that the cooker can get enough air to keep the flame burning correctly.
If the flame is starved for air it can give off dangerous carbon monoxide.
Carbon Monoxide is a clear odorless gas that can cause suffocation and death.
Be sure the burner tubes are COMPLETELY covered with water before
lighting the pilot or main burners. If the tubes are exposed, the cooker may
overheat, causing damage to the kettle, creating a fire hazard, and voiding the
warranty.
SAFETY
SAFETY
codes. If local codes do not apply, follow the requirements of
National Code ANSI/NFPA 70-1990.
DO NOT use an open flame to check for gas leaks!
SAFETY
SAFETY
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
SAFETY
SAFETY
SAFETY
SAFETY
SAFETY