Installation With Windows 95; Installing Network Software And Drivers - Allied Telesis AT-2450 Installation Manual

Pci ethernet adapter card

Hide thumbs Also See for AT-2450:

Table of Contents

Chapter 3

Installation with Windows 95

Run the CLEAN95 utility on the CardAssistant diskette

before inserting the AT-2450 adapter card in the computer.

1. Turn your computer on and boot into Windows 95. Insert

the ATI CardAssistant diskette into the 3.5" diskette drive.

Double-click the computer icon in the upper left-hand

corner of the screen.

3. Double-click the 3.5" diskette icon.

4. Double-click the CLEAN95.EXE icon.

5. Click the Install Drivers button. Check for the message:

"Driver installation successfully completed." Click the OK

button.

6. Remove the diskette, shutdown Windows 95, power off

your computer, and unplug it.

7. Install the adapter card by following the instructions that

came with your computer. See Chapter 2, "Installing the

Card in a PCI Slot." Then turn the computer on again.

8. Upon restarting your computer, Windows 95 finds the card

you installed. If prompted by Windows 95, insert the

Windows 95 setup CD-ROM or diskettes.

NOTE

Table of Contents

At-2450 bt At-2450 ft