Table of Contents
Advertisement
Hardware Installation
LED
Checking the
Installation
LNK/ACT (Link/Activity)
The LNK LED is green when the AT-WCP200G adapter is connected to a
network successfully. Otherwise the LNK LED blinks continuously while
the AT-WCP200G adapter is scanning the wireless devices or
transmitting data.
1.
Shut-down the computer by unplugging the power cord and
remove the chassis cover.
2.
Insert the contact edge of the AT-WCP200G adapter into the
connector or any available PCI Bus Master Expansion slot.
3.
Gently insert the card firmly into the PCI slot. Make sure the card is
securely seated.
4.
Secure the card to the chassis with the bracket screw.
5.
Replace the PC's cover.
6.
Turn the computer ON.
Refer to the next section to install the AT-WCP200G driver and
WIRELESS LAN utility.
AT-WCP200G User's Guide
17
Advertisement
Table of Contents
