Running Cardassistant In Dos Command-Line Mode - Allied Telesis AT-2450 Installation Manual

AT-2450 PCI Ethernet Adapter Card

Running CardAssistant in DOS Command-Line Mode

When you wish to prepare and configure several AT-2450 PCI
Ethernet Adapter Card cards for users in an assembly-line
approach, you can either use configuration parameters in the
command line or you can write a file that invokes CardAssistant
when read. The syntax for running CardAssistant in command-
line mode (from DOS) is as follows:
where
parameters
modify from their default values. If you intend to use the default
value for a parameter, it may be omitted.
Table 4 lists the parameters that may be set.
Table 4: Command-Line Mode Parameter Names
Parameter
port
/p =
/X
/d = mode
filename
/W =
filename
/R =
The parameter is a specialized switch that tells CardAssistant
/X
to perform diagnostic checks on the AT-2450 PCI Ethernet
Adapter Card installed in the computer instead of executing the
setup program. This switch should be used on its own (i.e.,
without specifying other parameters) and with no driver loaded.
22
setup24 [ parameters ]
is replaced with the parameters you wish to
Function
UTP, BNC, AUI, FIBER port, or
port =
AUTO
performs diagnostics
full or half-duplex (default)
mode =
writes configuration file
reads configuration file