Running Diagnostics Checks With Cardassistant - Allied Telesis AT-2450 Installation Manual

Pci ethernet adapter card

Hide thumbs Also See for AT-2450:

Table of Contents

Chapter 8

Running Diagnostics Checks with

CardAssistant

The ATI CardAssistant program is used for simple diagnostics

checks to confirm that the AT-2450 PCI Ethernet Adapter Card

is functioning properly. Diagnostics runs in DOS mode with no

drivers loaded. The following procedure allows you to boot

without loading drivers; for more information, see "Temporarily

Removing the Driver" on page 21, your operating system

documentation, and the individual readme file for your network

software on the CardAssistant diskette.

1. Run CardAssistant in DOS mode. To prevent the drivers

from loading, press one of the following when DOS begins

to boot:

to bypass all batch and configuration files

to step through batch and configuration files and by-

pass individual lines that load driver software

2. Insert the CardAssistant diskette into the appropriate

floppy drive (unless the program

hard drive).

3. Type:

path\ setup24

where

path\

4. The main menu comes up and you are ready to select the

card (or one of the cards if more than one is installed).

Select the Diagnostics menu.

Type:

is the optional drive and directory.

ENTER

is on your

setup24.exe

Table of Contents

At-2450 bt At-2450 ft