Setting The Parameters Specific To The Installation - REMEHA iSense Pro DIN AD280 Installation And Service Manual

iSense Pro DIN - AD280
0 2 4 6 8
E 1
TEMP.: 68°
2
1
D
2
# F
% $
AUTO
J I
5"
Installer level - #SYSTEM menu
Parameter Adjustment range Description
(1)
3WV
CIRC. B:
SWIM.P.
DIRECT
(1)
3WV
CIRC. C:
SWIM.P.
DIRECT
(1)
DHW LOOP
S.AUX:
PROGRAM.
PRIMARY PUMP
DHW
FAILURE
DHW ELEC
(1)
SYSTEM
I.SYST
STORAGE TANK
DHW STRAT
ST.TANK+DHW
(1) The parameter is only displayed if INSTALLATION parameter is set to EXTENDED
(2) The parameter is only displayed if the parameter IN 0-10V is set to OFF
12/04/2011 - 300025649-001-B
10 12 14 16 18 20 22 24
SUNDAY 11:45
 !
:
<
STD
C002235-F-04
Connecting a circuit with 3-way valve ( For example:
Underfloor heating)
Using the circuit for pool management
Use of circuit in direct heating circuit
Check and set the heating curve if necessary. See
¼ "Setting the heating curve", page
chapter:
37
Connecting a circuit with 3-way valve ( For example:
Underfloor heating)
Using the circuit for pool management
Use of circuit in direct heating circuit
Check and set the heating curve if necessary. See
¼ "Setting the heating curve", page
chapter:
37
Use as a domestic loop pump
Use as an independent programmable outlet
The outlet AUX PUMP is active if a heating demand is
present on the secondary pump
Use of primary circuit of second DHW tank
The outlet AUX PUMP is active if a fault is detected
Used to control the electrical resistor according to the
timer programme on circuit AUX in summer mode
The inlet sensor is used to connect the common flow
sensor of a cascade system
Hot water storage tank affected to heating only
Using the DHW tank with 2 sensors (top and bottom)
Hot water storage tank affected to heating and
domestic hot water
Regardless of what is done to the keys, the regulator
switches back to CLASSIC mode after 30 minutes.
5.5.2. Setting the parameters specific to the
installation
1. Access the installer level: Press key - for around 5 seconds.
2. Select the menu #SYSTEM.
Turn the rotary button to scroll through the menus or
4
modify a value.
Press the rotary button to access the menu selected
4
or confirm a value modification.
¼ For a detailed explanation of menu browsing, refer
to the chapter: "Browsing in the menus", page 31
3. Set the following parameters according to the connections made
to the PCBs:
5. Operating the appliance
Factory setting Customer
setting
3WV
3WV
DHW LOOP
SYSTEM
34