Xerox Versant 3100 Quick Start Manual page 22

Maintenance
2. Lay paper on the floor before removing the cartridge. This will allow any excess dry
ink / toner to fall on the paper.
3. Slowly remove the dry ink / toner cartridge by placing fingers under the end of the
cartridge and gently pulling it straight out. While pulling out, hold the bottom of the
cartridge with your other hand to give it support.
Ensure that you are removing the same cartridge that matches the color as indicated
in the message.
4. Dispose of or recycle the cartridge per your local authorities and regulations.
In the United States, also refer to the Electronic Industries Alliance website:
www.eiae.org. For more information about Xerox environmental programs, go to
www.xerox.com/environment.
5. Remove the new dry ink / toner cartridge from its packaging.
6. Prepare the cartridge for installation:
Note
The dry ink / toner material inside the new cartridge is compact. Loosen and
redistribute the dry ink / toner material before placing into the dry ink / toner slot.
a) With one hand on either side of the cartridge, vigorously shake and rotate the
new cartridge up and down and then left and right for 30 seconds.
b) Test whether the dry ink / toner material is distributed sufficiently by turning the
auger on the end of the cartridge.
c) If the auger does not turn easily, continue to shake the cartridge and loosen the
dry ink / toner material. When the auger turns without resistance, the dry ink /
toner cartridge is ready for installation.
4-4 Xerox ® Versant ® 3100 Press
Quick Start Guide