Table of Contents
Advertisement
Verify the Correctness of Installation
After finalizing the full Smappee installation, and while testing the Smappee
measurements, you should specifically verify the correct wiring of the 8-pin connector
block.
These checks will be explained at a later step during the installation, at section
"Checklist for Correct Configuration", on page 29.
Smappee Plus Installation Manual
Page 10 of 32
Version 1.6.2 B, 20-06-2017, rev 4
Advertisement
Table of Contents
Need help?
Do you have a question about the Smappee Plus and is the answer not in the manual?