Parameters - Siemens SIMATIC ET 200SP Manual

Parameters/address space

4.2 Parameters

4.2 Parameters
Parameters of AI 2×I 2-/4-wire ST
The effective range of the configurable parameters depends on the type of configuration.
The following configurations are possible:
● Central operation with an ET 200SP CPU
● Distributed operation on PROFINET IO in an ET 200SP system
● Distributed operation on PROFIBUS DP in an ET 200SP system
When assigning parameters in the user program, use the "WRREC" instruction to transfer
the parameters to the module using the data records; refer to section Parameter assignment
and structure of the parameter data record (Page 29).
The following parameter settings are possible:
Table 4- 2 Configurable parameters and their defaults (GSD file)
Parameter
Diagnostics:
No supply voltage L+
Diagnostics:
Short-circuit to ground
Diagnostics:
Overflow
1
Diagnostics:
Underflow
1
Diagnostics:
Wire break
Measurement
type/measuring range
14
Range of values
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Deactivated
•
Current (4-wire transducer)
•
0 to 20 mA
Current (4-wire transducer)
•
4 to 20 mA
Current (4-wire transducer)
•
+/- 20 mA
Current (2-wire transducer)
•
0 to 20 mA
Current (2-wire transducer)
•
4 to 20 mA
Default Configura-
tion in RUN
Disable Yes
Disable Yes
Disable Yes
Disable Yes
Disable Yes
Current (4- Yes
wire trans-
ducer) 4 to
20 mA
Analog input module AI 2xI 2/4-wire ST (6ES7134-6GB00-0BA1)
Effective range with configura-
tion software, e.g. STEP 7
(TIA Portal)
GSD file GSD file
PROFINET IO PROFIBUS DP
Channel Channel
Channel Channel
Channel Channel
1
Channel
Channel Channel
Channel Channel
Manual, 12/2015, A5E36104399-AA