For information outside Australia please visit the website of your local aviation authority. • Do not attempt to modify the Scout or any of its components in any way, doing so will void your warranty and may affect the operation of the drone.
BATTERY SAFETY When handled incorrectly, Lithium polymer batteries can be dangerous and can potentially harm and do damage to persons or property. Zero-X does not accept any liability for damage to persons or property if the battery is not correctly charged, stored or protected.
INTRODUCTION 2.1 PACKAGE CONTENTS Scout Remote Control Rotor Blades USB Charging Cable Battery Screwdriver AC Wall Charger Camera Feet 10. Rotor Guards 11. User Guide Capture the skies.™...
2.2 PRODUCT OVERVIEW SCOUT DIAGRAM Rotor blades Feet Power Switch Rotor Guards Battery Hatch/Flap Camera * Micro SD Card not included REMOTE CONTROL DIAGRAM Antenna Directional Lock Left Thumb Stick Throttle Trimming YawTrimming Flip Button Power Switch Right Thumb Stick 9.
Overcharging will damage the battery and effect the flight time. • The Scout battery can take up to 90 minutes to fully charge. If the battery has been on charge for any longer than 2 hours and the indicator on the charging cable is not showing that the battery is charged please remove the battery from the charger.
3.3 CAMERA CONNECTION GUIDE 1. Connect the camera connection wire to the socket on the under side of the Scout. Be sure to connect the cable in the correct orientation, connecting the cable the wrong way can cause damage to the connection.
3.6 FEET INSTALLATION Line up the guide pegs on the feet with the holes on the underside of the Scout’s body so that the screws in the feet match up with the screw holes on the underside of the Scout.
4.2 TROUBLE SHOOTING Do not approach the drone again until the remote has been powered off. If for any reason the Scout does not work after following the above steps please check the following. a) The Scout battery is fully charged, correctly connected and not damaged.
Speed Button marked with two arrows on the bottom right of the controller. When the Scout is powered up it will start in LOW speed mode. In this mode, the Scout will control and fly slowly. It is advised that beginners use this mode to learn the basics before moving onto the two higher modes.
Scout is launched will always be forward on the controls, no matter which way the Scout is facing. This means that even if you can’t see which way the Scout is facing you will be able to bring the drone back towards yourself by pulling back on the Right Thumbstick (Pitch/Roll).
Different colour Rotor Blades are used front and back on your Scout so it is easy to identify the front and rear of the Scout when flying. To ensure that it is easy to fly the Scout make sure that the front and rear blades are different colours.
To thank you for your support of Zero-X and your drone purchase, we would like to help you build you confidence in learning how to fly your drone. We would like to offer you 50% off your first two orders of any spare parts, by using the codes in the coupons below.
The retailer will then return the goods to Zero-X. Zero-X will repair, replace or refurbish the product at its discretion. The retailer will contact you when the product is ready for collection.
Need help?
Do you have a question about the Scout and is the answer not in the manual?
Questions and answers