Flying Your Scout; Troubleshooting - ZERO-X Scout User Manual

4.1 FLYING YOUR SCOUT

1. After installing a fully charged
2. Once on, the LED lights on the arms
3. With
4. To activate the connection between
4.2 TROUBLE SHOOTING
Do not approach the drone again until the remote has been powered
off. If for any reason the Scout does not work after following the
above steps please check the following.
a) The Scout battery is fully charged, correctly connected and not
b) The batteries in the Remote Control are the same brand, have an
c) The connection between the Remote Control and the Scout
Once these elements have been checked, turn both the Scout and
the Remote Control off and start the launching process again.
_12
Capture the skies.™
battery and installing 4 x AA
batteries (AA
included) into the remote control
and conducting a complete check
of your surroundings, turn the
Power Switch on the Scout to the
ON position.
of the Scout should flash signalling a
connection to the Remote Control.
Place the Scout on the ground
facing away from you and move back three metres.
the Left
(Acceleration/Yaw) in the lowest
(down) position power on the
remote control. The remote should
beep once to indicate power up has
been successful.
the remote and the Scout, move
the Left Thumbstick (Acceleration/
Yaw) on the Remote Control to the
highest (up) position. Hold for one
second and then return the Left
Thumbstick (Acceleration/Yaw) to
the lowest (down) position.
damaged.
equal amount of charge and have enough charge to power the
remote control correctly (using an assortment of batteries will affect
the performance of the Remote Control).
drone may not have been completed correctly. Ensure that when
activating the connection, the Left Thumbstick is moved all the
way to the top and then all the way to the bottom. If this is not
completed the connection will not activate.
batteries not
Thumbstick