Table of Contents
Advertisement
Rubber Track Loader
13. Maintenance
Bleeding the Fuel System
The tools required for bleeding the fuel system are
listed below. Use manufacturer-recommended tools
whenever possible.
Table 16-1
Required Tools
Combination Wrench
If the machine has been run out of fuel, it may be
necessary to bleed the fuel system.
Figure 11-25
1. Locate the bleed screw directly above the fuel
injection pump.
2. Loosen the bleed screw two full turns.
Figure 11-27
3. Pump the bulb primer with your hand until fuel
flows from the bleed screw without any air bub-
bles.
4. Tighten the bleed screw.
Bleed
Screw
13-6
Advertisement
Table of Contents
