Rubber Track Loader
10. Transmission and Drive Disassembly and Assembly
Figure 10-7
9. Remove the mounting bolt (with spring lock
washer and flat washer) from the right-hand side
of the tandem pump.
Remove
Bolt
Figure 10-8
10. Remove the mounting bolt (with spring lock
washer and flat washer) from the left-hand side
of the tandem pump, then remove as shown.
Pump Drive
Coupler
Pump
Mounting
Plate
Figure 10-9
Tandem Pump Installation
Remove
Bolt
10-4
Pump Drive
Coupler
Flywheel
Gear
Pump
Mounting
Plate
Figure 10-10
Figure 10-11
1. Install the pump and mounting bolts/washers as
found upon removal. Apply blue loctite to the
threads of each bolt, then tighten to 85 ft.-lb (115
Nm).
Figure 10-12
2. Reconnect the hoses and tubes to the tandem
pump as found upon removal.
3. Install the auxiliary gear pump. Refer to Chapter
10. Auxiliary Gear Pump Installation.
Install
Bolt