Ignition Switch Installation - Terex PT-50 Service Manual

Remove Nut
Figure 5-7
2. Remove the nut that secures the ignition switch
to the dash panel.
Figure 5-8
3. Pull the ignition switch out from the rear of the
dash panel.
Figure 5-9
4. Unplug the ignition switch connector.
5. Operator Enclosure Disassembly and Assembly

Ignition Switch Installation

Figure 5-10
1. Insert the ignition switch from the rear of the
dash panel.
Install Nut
Figure 5-11
2. Install the nut that secures the ignition switch to
the dash panel.
Figure 5-12
3. Plug in the ignition switch connector.
5-3
Rubber Track Loader