Table of Contents
Advertisement
Rubber Track Loader
6. Chassis Disassembly and Assembly
Unplug
Connector
Figure 6-2
2. Tilt the seat forward and reach behind the seat
to unplug the seat switch wiring harness.
Figure 6-3
3. Remove the seat. Be careful not to scratch the
control panel or sides of the cab.
Seat Installation
Figure 6-4
1. With the seat mounts attached, place the seat in
the cab. Be careful not to scratch the control
panel or sides of the cab.
Plug in the Connector
Figure 6-5
2. Tilt the seat forward and reach behind the seat
to plug in the seat switch connector
Note: The machine will not operate unless the seat switch
connector is plugged in.
insert Seat Bolts
Figure 6-6
3. Position the seat so the holes in the seat mounts
are aligned with the bolts in the frame. Install the
four seat mount nuts and washers.
Fuel-Sending Unit Removal
and Installation
The tools required for fuel sending unit removal and
installation are listed in Table 6-2. Use manufactur-
er-recommended tools whenever possible.
Table 6-2
Required Tools
Screwdriver
Combination Wrench
Socket Wrench
6-2
Advertisement
Table of Contents
