Start Up The System - Cisco TelePresence MX700 Installation Manual

Single camera mounted on the wall

Hide thumbs Also See for TelePresence MX700:

Installation guide for Cisco TelePresence MX700 Single camera - Wall mount

Start up the system

•

Remove the protection foil from the displays.

•

Make sure that the camera can move freely.

•

Insert the network and power cables into the wall outlets.

•

Switch on the system.

The power switch is located directly below the codec, next to the

power connector.

Wait a few minutes while the system starts up. The start-up may

include automatic software upgrade and restart of Touch 10 and

camera.

If the right monitor does not turn on after the start-up sequence,

check that the power cable between the monitors are properly

connected (refer to step 10 and step 12).

•

Follow the instructions on the Touch controller.

Cisco Spark: To find more information on how to get started with

Spark registered systems, visit

for Getting Started articles for room systems.

Other services: For further information on set-up and configuration,

download the Getting Started Guide from the Cisco web site,

http://www.cisco.com/go/mx-docs

http://help.ciscospark.com

and look

Page 30

Table of Contents