Cisco TelePresence MX700 Installation Manual page 7

Single camera mounted on the wall

Hide thumbs Also See for TelePresence MX700:

Installation guide for Cisco TelePresence MX700 Single camera - Wall mount

Mount left wall bracket

Check that the wall bracket is level and mark the required

screw hole positions on the wall. Use at least four screws

when fastening the wall bracket. The wall bracket can be

fastened through any of the horizontal slots.

Fasten the wall bracket in a secure manner ensuring that

the wall's structure is sufficient to support the system load

(screws and mounting hardware not provided; not shown in

illustration).

The lower edge of the screen

image will be at the height of

these horizontal slots.

We recommend that the

distance from the floor to this

line is 70 cm / 27.6 in.

If you mount the system higher, note the following consequences:

- You may need to increase the distance between the video system and the table in

order for the camera to capture the closest participants.

- The camera gives an elevated view of the room. This view is not optimal for video

conferencing.

Further information:

http://www.cisco.com/go/projectworkplace

2D CAD drawings with measurements:

References)

http://www.cisco.com/go/mx-docs

(Technical

Page 7

Table of Contents