Cisco TelePresence MX700 Installation Manual page 14

Installation guide for Cisco TelePresence MX700 Single camera - Wall mount
10
Fasten left monitor and connect power cable
4 × M6x35, countersunk
2 × M6x90, countersunk
2 × M6x100, pan
2 × Bracket
78-100254-03A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
Enter the following screws:
1
• Four M6x35 screws, from front.
• Two M6x90 screws, from underneath.
• Two M6x100 screws and their brackets, from
underneath.
Then, tighten all screws.
Connect power cable
2
A power cable is strapped at the rear of the
monitor. Connect it to the close-by socket.
Let the other end hang freely. It will be
connected to the right monitor in step 12.
Rear view
Left side of the
monitor, viewed
from underneath
Right side of the
monitor, viewed
from underneath
Page 14