Cisco Nexus 9508 Hardware Installation Manual page 98

Removing a Fan Tray
If the module is damaged, contact the Technical Assistance Center (TAC) and wait until you have an undamaged fan
tray to install.
Step 2 Unscrew the four captive screws on the front of the fan tray until each screw is free of the chassis (see the following
figure).
1 Unscrew 4 captive screws (2 at the top of the module
and 2 at the bottom of the module).
2 Hold the 2 fan tray handles with both hands.
Step 3
Hold both handles on the front of the fan tray with both of your hands and pull the fan tray out of the slot.
Step 4 Set the fan tray on antistatic material or inside an antistatic bag.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
88
Replacing or Installing Modules, Fan Trays, and Power Supplies
3 Pull on the fan tray to slide it out of the chassis. Set
the fan tray on an antistatic surface.