Vega VEGACAP 62 Operating Instructions Manual page 16

With two-wire output

Hide thumbs Also See for VEGACAP 62:

Table of Contents

Connecting to power supply

3 Remove approx. 10 cm (4 in) of the cable mantle, strip

approx. 1 cm (0.4 in) insulation from the ends of the

individual wires

4 Insert the cable into the sensor through the cable entry

5 Lift the opening levers of the terminals with a screwdriver

(see following illustration)

6 Insert the wire ends into the open terminals according to

the wiring plan

7 Press down the opening levers of the terminals, you will

hear the terminal spring closing

8 Check the hold of the wires in the terminals by lightly

pulling on them

9 Tighten the compression nut of the cable entry, the seal

ring must completely encircle the cable

10 Screw the housing cover back on

The electrical connection is ﬁnished.

Fig. 7: Connection steps 5 and 6

VEGACAP 62 - with two-wire output

Table of Contents