Handset Battery Charging - Southwestern Bell Freedom Phone GH4000 Owner's Manual

INSTALLATION

Handset Battery Charging:

The battery pack in the handset must be fully charged for about 10-14
hours before using the telephone. After connecting to AC power, leave
the handset unused in the cradle for ten to fourteen hours. Later, it will
take less time for the battery to recharge. The CHARGE LED on the
handset charger will be lit and if the handset battery low will display
"CHARGING" when the handset is in handset charger.
NOTE:
a. When the battery gets low, the Battery Low ln dicator
will turn on.
b. If the battery becomes low while you are on a call, you
will be disconnected after about 30 seconds. Terminate the
call quickly, and put the handset in the handset charger to
recharge the battery.
c. The battery will hold its charge for several days out of
the cradle, depending on use.
NOTE: The handset will not ring when the ringer is in the
"OFF" position. If the handset is out of the cradle, it will
display"RING" during an incoming call.
To maximize your battery's life, we recommend that you periodically
fully discharge the battery, and then recharge it. To do this, unplug your
phone line cord from the wall phone jack. Press the TALK button, and
allow the handset to remain on for 10 to 12 hours. Reconnect the phone
cord to the wall phone jack. Return the handset to the handset charger
and allow it to fully charge for 12 hours. If this process is completed
monthly, it will reduce the memory buildup that occurs from frequent
partial charging.
14
To Replace Batteries:
1. Remove battery cover.
2. Remove old battery.
3. Plug the cord of the battery pack into the
handset and place the battery in the case.
4. Slide battery cover until it clicks in place.
Charge 10-14 hours before first use.