Table of Contents
Advertisement
INSTALLATION
Handset Battery Charging:
The battery pack in the handset must be charged for about 10 hours
before using the telephone. After connecting to AC power, leave the
handset unused in the cradle for ten hours. Later, it will take less time
for the battery to recharge. The CHARGE LED on the handset charger
will be lit and the handset will display "READY ".
NOTE:
a. When the battery gets low, the Battery Low lndicator will
turn on.
b. If the battery becomes low while you are on a call, you
will be disconnected after about 30 seconds. Terminate the
call quickly, and put the handset in the handset charger to
recharge the battery.
c. The battery will hold its charge for several days out of
the cradle, depending on use.
NOTE: The handset will not ring when the ringer is in the
"OFF" position. If the handset is out of the cradle, it will
display"RINGING" during an incoming call.
To maximize your battery's life, we recommend that you periodically
fully discharge the battery, and then recharge it. To do this, unplug your
phone line cord from the wall phone jack. Press the TALK button, and
allow the handset to remain on for 10 hours. Reconnect the phone cord
to the wall phone jack. Return the handset to the handset charger and
allow it to fully charge for 10 hours. If this process is completed monthly,
it will reduce the memory buildup that occurs from frequent partial
charging.
To Replace Batteries:
1. Remove battery cover.
2. Remove old battery.
3. Plug the cord of the battery pack into the
handset and place the battery in the case.
4. Slide battery cover until it clicks in place.
Charge 10 hours before first use.
PROG
CANCEL
TALK
FLASH
ABC
2
DEF
1
3
JKL
GHI
5
MNO
4
6
TUV
PQRS
8
WXYZ
7
9
OPER
0
*
#
CHARGE
Southwestern Bell
Freedom Phone
13
Advertisement
Table of Contents
