Headset Jack; Incoming Call - Southwestern Bell Freedom Phone GH4000 Owner's Manual

2.4 ghz / digital spread spectrum cordless telephone with call waiting caller id
Hide thumbs Also See for Freedom Phone GH4000:
Table of Contents

Advertisement

TELEPHONE OPERATION
the following ways: if the battery is
drained and needs recharging: the
handset is out of range of the base
u n i t ; t h e A C a d a p t o r i s
disconnected or a power loss has
occurred; or anything that causes
electrical interference, for example
m u l t i p l e c o r d l e s s t e l e p h o n e s .
Reset the base for 10 seconds. If
that does not work, make sure the
AC adaptor from the power source.
D i s c o n n e c t t h e b a t t e r y f o r 5
seconds on the base and then
reconnect. Place the handset on the
base and the replug the AC adaptor
(see Trouble shooting).

Headset Jack

You can connect a headset (not
i n c l u d e d ) f o r h a n d s - f r e e
conversations.
1.Insert the headset plug (must be
3/32 inch/2.5mm type)into the
headset jack on the side of the
handset (You may need to lift the
rubber protective cover from the
jack).
2.Attach the belt clip to the back of
the handset. Make sure the"arms"
of the belt clip snap securely into
the notches on the side of the
handset. You can now attach the
hand set/belt clip to the desired
location on your clothing.
3.Adjust the headset microphone to
a comfortable position, placing it
near your mouth.
4.Use the TALK button to make or
receive a call.
5.To remove the belt clip from the
back of the handset, use your
fingernails to loosen one of the
"arms"of the belt clip. The other
" a r m " o f t h e b e l t c l i p w i l l
automatically release from the
handset.
N o t e : W h e n t h e b e l t c l i p i s
connected to the handset, the
handset can only charge correctly
with the keypad facing into the
base.

Incoming Call

T
he same procedure applies to all
incoming calls, i.e. external and
internal (intercom and conference
call).
Incoming Call - Handset
1.If auto answer is disabled, an
i n c o m i n g c a l l i s a c c e p t e d b y
removing the handset from handset
charger, or pressing TALK or any
numerical key (0 to 9), * or # key.
2.If auto answer is enabled, the
i n c o m i n g c a l l i s a c c e p t e d b y
removing the handset from the
charger.
3 . T h e c a l l i s t e r m i n a t e d b y
19

Advertisement

Table of Contents
loading

Table of Contents