Connect the discovery service cable.
10.
Install the fan cage.
11.
Install the access panel (on page 28).
12.
Slide the server into the rack.
13.
Connect each power cord to the server.
14.
Connect each power cord to the power source.
15.
Power up the server
16.
Smart Storage Battery
To install the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 26).
o
Remove the server from the rack (on page 27).
o
Remove the access panel (on page 27).
4.
Remove the air baffle (on page 32).
5.
Remove the fan cage (on page 29).
6.
("Powering up the
server" on page 26).
Hardware options installation 114