Insert the power supply into the power supply bay until it clicks into place.
3.
Connect the power cord to the power supply.
4.
Route the power cord. Use best practices when routing power cords and other cables. A cable
5.
management arm is available to help with routing. To obtain a cable management arm, contact a
Hewlett Packard Enterprise authorized reseller.
Connect the power cord to the AC power source.
6.
Be sure that the power supply LED is green
7.
High-performance fan option
To install the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 26).
o
Remove the server from the rack (on page 27).
o
("Rear panel
LEDs" on page 14).
Hardware options installation 56