Install the TPM board. Press down on the connector to seat the board
6.
on page 16).
Install the TPM security rivet by pressing the rivet firmly into the system board.
7.
Install the PCI riser cage (on page 31).
8.
Install the access panel (on page 28).
9.
Install the server into the rack
10.
Power up the server
11.
Retaining the recovery key/password
The recovery key/password is generated during BitLocker setup, and can be saved and printed after
BitLocker is enabled. When using BitLocker, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker detects a possible compromise of
system integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
•
Always store the recovery key/password in multiple locations.
•
Always store copies of the recovery key/password away from the server.
("Installing the server into the
("Powering up the
server" on page 26).
("System board
rack" on page 39).
Hardware options installation 138
components"