Table of Contents
Advertisement
Lite-12
Description of the device
Features
The Showtec Lite-12 is a light controller equipped with a 12-channel chaser, 7 operating modes, 53
chasing programs, memory backup and fade time control.
• Input voltage: 230V AC, 50Hz
• Power input: DC 15-18V, 300mA
• Audio input: 100mV-2Vpp
• Connections: 3-pin DMX signal connector OUT
• Dimensions:
483 x 133 x 51 mm (LxWxH)
19" x 3 HE
• Weight: 2,3 kg
Overview
01) Channel dimmer Indicator: This indicator shows the dimming level of the corresponding channel.
02) Channel dimmer fader: Move the faders to adjust the dimming level of the corresponding channel.
03) Channel flash button: Press to activate the channel's FULL ON function.
04) Mode LED indicators: These indicators show the currently active operating mode.
05) LED display
06) Master dimmer indicator: This indicator shows the master dimming level.
07) Audio level indicator: This indicator shows the device's sensitivity to the beat of music.
08) Speed Indicator: This indicator shows the chasing speed.
09) Mode Select button: Press to select the desired operating mode. The available operating modes are:
Hold Dimmer / Hold Sound / Prog Sound / Prog Speed/ Auto Speed / Auto Sound / Memory or music
control from line input / built-in microphone.
10) Prog Select button: Press to select the desired program. There are 53 pre-set programs in Prog Sound
/ Prog Speed / Auto Speed / Auto Sound. In Memory mode, press the button to activate sub-mode
to select the desired operating mode from Program / Manual / Auto Sound / Auto Speed, using the
STAND BY button.
11) Fade control fader: Move the fader to adjust the delay time. It is not effective in Hold Sound mode.
12) Stand-by button & indicator: Press to pause all output.
13) Master dimmer fader: Move the fader to adjust the master dimmer.
14) Full On button: Press to activate FULL ON function for the whole output.
15) Audio level fader: Move the fader to adjust the device's sensitivity to the beat of music, detected by
the built-in microphone or line in.
16) Tap Sync button: This button is effective only in Prog Speed and Auto Speed. Press to define chasing
speed. When you press this button twice within 10 minutes, the interval between two pressings will be
assigned to chasing speed.
17) Speed fader: Move the fader to adjust the chasing speed.
18) Power switch ON/OFF
Ordercode: 50336
5
Fig. 01
Advertisement
Table of Contents
