Supermicro X11DPU User Manual page 15

I/O Devices
•
Serial (COM) Port
•
SATA 3.0
•
RAID (PCH)
Peripheral Devices
•
Two (2) USB 3.0 ports on the rear I/O panel (USB 0/1)
•
One (1) internal USB 3.0 header with two (2) USB connections on the motherboard for front access (USB 3/4)
•
One (1) Type A USB 3.0 connector for front access (USB 2)
BIOS
•
64 MB SPI AMI BIOS SM Flash UEFI BIOS
®
•
ACPI 3.0/4.0, USB keyboard, Plug-and-Play (PnP), SPI dual/quad speed support, riser-card auto detection support, and
SMBIOS 2.7 or later
Power Management
•
Main switch override mechanism
•
Power-on mode for AC power recovery
•
Intel® Intelligent Power Node Manager 4.0 (available when the Supermicro Power Manager [SPM] is installed and a
special power supply is used. See the note on page 22.)
•
Management Engine (ME)
System Health Monitoring
•
Onboard voltage monitoring for +3.3V, 3.3V standby, +5V, +5V standby, +12V, CPU core, memory, chipset, BMC, PCH,
and battery voltages
•
CPU System LED and control
•
CPU Thermal Trip support
•
Status monitor for speed control
•
Status monitor for on/off control
•
CPU Thermal Design Power (TDP) support of up to 165W (See Note 1 on next page.)
Fan Control
•
Fan status monitoring via IPMI connections
•
Dual cooling zone
•
Low-noise fan speed control
•
Pulse Width Modulation (PWM) fan control
System Management
•
Trusted Platform Module (TPM) support
•
PECI (Platform Environment Control Interface) 2.0 support
•
UID (Unit Identification)/Remote UID
•
System resource alert via SuperDoctor® 5
•
SuperDoctor® 5, Watch Dog, NMI
•
Chassis intrusion header and detection
Note: The table above is continued on the next page.
Motherboard Features
•
One (1) Fast UART 16550 port on the I/O back panel
•
Eight (8) SATA 3.0 connections supported by Intel® PCH (I-SATA 0-3, 4-7)
•
Four (4) SATA 3.0 connections supported by Intel® SCU (S-SATA 0-3)
•
Two (2) SATA 3.0 ports with power-pin built-in, w/support of Supermicro
SuperDOM (S-SATA4/S-SATA5)
•
RAID 0/1/5/10 (RSTe 5.0)
15
Chapter 1: Introduction