Matrox MXO2 Installation And User Manual page 251

you can change the setup to 0 IRE to output the video at the correct
brightness.
•
7.5 IRE
Applies the standard NTSC setup level of 7.5 IRE.
YUV/RGB
$ Select
sent from the component output. For example, select
connected the component output to a device that accepts an RGB signal.
Under HDMI Output
$
sent from the HDMI output:
• YUV
Outputs YUV HDMI video. Select this only if you connected
the HDMI output to a device that accepts a YUV signal.
•
RGB - calibrated
currently loaded Matrox HDMI calibration settings for your HDMI
monitor or television. For details on calibrating your HDMI monitor
and loading calibration settings using the Matrox HDMI Calibration
Chapter 7, "Calibrating Your HDMI Monitor for
Utility, see
•
RGB - native
any calibration compensation. Select this when you want to disable the
currently loaded Matrox HDMI calibration settings and output RGB
HDMI video from MXO2 using its native color settings for previewing
video on your HDMI monitor.
2 Under SDI Audio Output Format
embedded SDI audio output (
on MXO2 Mini.
Analog Audio Volume
3 Under
analog audio output. By default, the sliders are locked so that they move
together. To move each slider independently, click the lock button (
disable it.
Advanced
4 Under , you can use the
delay your analog video output's subcarrier phase with respect to the
horizontal sync of the genlock source (for composite video only). This
setting is not available on MXO2 Mini.
OK
5 Click to save your settings.
YUV RGB
or to set the type of video signal that is
, select the type of video signal that you want to be
Outputs adjusted RGB HDMI video using the
Outputs native RGB HDMI video that does not apply
, select the bit depth you want for your
20-bit or 24-bit ). This setting is not available
, drag the sliders to adjust the volume of your
Analog SC/H Phase
Specifying your output settings
RGB
if you
Video."
) to
slider to advance or
231