Matrox MXO2 Installation And User Manual page 114

94
Under
10
conversion that you want to be applied to your captured video (used when
upscaling or downscaling video during capture only):
$
video by adding black bars at the top and bottom of the picture for display
on a standard 4:3 television screen.
$
adding black bars at the left and right sides of the picture for display on a
widescreen 16:9 television screen.
$
compressed 4:3 video, which retains the picture's full vertical resolution
for display on a widescreen television. To display the video with the
correct proportions on an NTSC or PAL monitor, select the 16:9 display
setting on the monitor.
$
the left and right sides of the picture for display on a standard 4:3
television screen.
$
top and bottom edges of the picture for display on a widescreen 16:9
television screen.
If you're capturing Panasonic VariCam material, select
11
capture
Matrox MXO2 will remove the redundant (filler) frames from the VariCam
input during capture and create a clip in the same format as your sequence
for editing.
¡ Important When you select
captured. When batch capturing VariCam clips, you must indicate that you
want to capture video only by selecting
Capture
12 Select
composite or S-Video input signal to be adjusted automatically to
compensate for very bright or dark images. This improves the brightness or
contrast of your picture.
13 From the
capture:
$
broadcast-quality. This setting provides the best capture results for most
devices.
$
capturing video because your source device doesn't meet
Chapter 9, Using Matrox MXO2 with Adobe Premiere Pro
Aspect Ratio Conversion
16x9 Letterbox
Captures the widescreen 16:9 picture as letterbox
4x3 Pillarbox
Captures the standard 4:3 picture as pillarbox video by
Anamorphic
Captures the widescreen 16:9 picture as horizontally
Center Cut Captures the widescreen 16:9 picture by evenly cropping
Center Zoom
Captures the standard 4:3 picture by evenly cropping the
(supported only for a 720p @ 23.98 fps or 25 fps sequence).
Setup.
panel under
Use Automatic Gain Control (AGC)
list, select the type of equipment you're using for
Input Type
Broadcast-quality Source
Consumer-quality Source
, specify the type of aspect ratio
Enable VariCam capture
Video on the
if you want the gain of your
Select this if your source device is
Select this if you're having problems
Enable VariCam
, audio cannot be
Logging pane of the