Lenovo ThinkStation P510 Hardware Maintenance Manual page 163

To install or replace the super capacitor module, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 99.
2. Lay the computer on its side for easier access to the super capacitor module.
3. Locate the PCI Express card slot in which the super capacitor module holder is installed. See "Computer
components" on page 33.
4. If necessary, remove the direct cooling air baffle for easier operation. See "Direct cooling air baffle" on
page 101.
5. Depending on whether you are installing or replacing the super capacitor module, do one of the following:
• If you are installing the super capacitor module, go to step 7.
• If you are replacing the super capacitor module, do the following:
a. Disconnect the super capacitor module cable from the RAID card.
b. Remove the holder with the failing super capacitor module from the PCI Express card slot in which
it is installed. See "PCI card" on page 149.
c. Gently pivot the plastic retaining clip
capacitor module from the bracket at the same time.
Figure 109. Removing the super capacitor module from the bracket
6. Touch the static-protective package that contains the new super capacitor module and its holder to any
unpainted surface on the outside of the computer. Then, remove the new super capacitor module and
its holder from the package.
1 on the bracket as shown and remove the failing super
Chapter 9
1
.
Installing or replacing hardware
157