Power Supply Assembly - Lenovo ThinkStation P510 Hardware Maintenance Manual

6. Align the four tabs at the bottom of the storage drive bay with the slots on the new blind-connect board.
Then, press down the board and slide it as shown until it snaps into position.
Figure 95. Installing the blind-connect assembly
7. Connect the SAS cable to the SAS connector on the RAID card.
8. Connect the power cable to the 4–pin power connector on the system board. See "Parts on the
system board" on page 35.
9. If your blind-connect assembly comes with two additional cables
connectors 2 on the flex adapter as shown.
Figure 96. Connecting the blind-connect assembly to the flex adapter
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 189.

Power supply assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
1 , connect them to the two PCIe
.
Chapter 9 Installing or replacing hardware
147