Lenovo ThinkStation P510 Hardware Maintenance Manual page 159

• If you are replacing an old PCI card, grasp the old card that is installed and gently pull it out of the slot.
Notes:
– If the PCI card is connected to another device, disconnect the cable from the card first.
– The card fits tightly into the slot. If necessary, alternate moving each side of the card a small
amount until the card is removed from the slot.
– If the card is held in place by a retaining latch, press the card retaining latch
disengage the latch. Grasp the card and gently pull it out of the slot.
Figure 104. Removing a PCI card
6. Remove the new PCI card from its static-protective package.
7. Install the new card into the appropriate slot on the system board. See "Parts on the system board"
on page 35.
Note: If the new PCI card needs to be connected to another device, connect the cable of the device
to the new PCI card.
8. Pivot the PCI card latch to the right and push it back in until it snaps into position.
1
.
Chapter 9 Installing or replacing hardware
as shown to
153