Front Panel I/O Cable - Lenovo ThinkStation P510 Hardware Maintenance Manual

3. Align the notch 1 of the microprocessor socket cover with the alignment key
socket. Lower the socket cover straight down into the microprocessor socket on the system board.
Figure 137. Installing the microprocessor socket cover
Note: Your microprocessor socket and cover might look slightly different from the illustration.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 189.

Front panel I/O cable

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
CAUTION:
The heat sink and microprocessor might be very hot. Before you open the computer cover, turn off
the computer and wait several minutes until the computer is cool.
To remove the front panel I/O cable, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 99.
2. Remove the direct cooling air baffle. See "Direct cooling air baffle" on page 101.
3. Lay the computer on its side for easier access to the system board.
4. Remove all PCI or PCI Express cards that are installed. See "PCI card" on page 149 or "Full-length
PCI card" on page 154.
5. Remove the optical-drive bracket. See "Optical-drive bracket" on page 122.
6. Remove the flex adapter if it is installed. See "Flex adapter" on page 165.
7. Remove the front fan assembly. See "Front fan assembly" on page 126.
8. Remove any rear fan assembly that is installed. See "Rear fan assembly" on page 159.
9. Remove the power supply assembly. See "Power supply assembly" on page 147.
10. Remove the memory modules that are installed. See "Memory module" on page 163.
11. Remove any heat sink and fan assembly that is installed. See "Heat sink and fan assembly" on page 161.
12. Record the cable routing and cable connections, and then disconnect all cables from the system board.
See "Parts on the system board" on page 35.
2 of the microprocessor
.
Chapter 9 Installing or replacing hardware
177